New Firmware and Application Notes for DrayTek Products ( 25 October 2017)
DrayTek Load Balance Route Policy
Load Balance/Route Policy is a feature in DrayTek routers where a set of defined rules or “policies” directs traffic to the specified interface when conditions are met. This video provides an overview of this feature.
New Application Notes
Introduction of DrayTek AP Management(APM) Solutions
This application note gives an introduction of DrayTek Access Point Management and management options available.
[Vigor3900] How to configure WAN Inbound Load Balance in Failover mode?
Inbound Load Balance is a feature allowing the Vigor3900/2960/300B routers to be the authoritative name server for domain names. The router can automatically reply its WAN IP to the internet clients querying domain names. In addition, it can do Load Balance or Failover if the router has multiple WAN interfaces. This application note shows how to use Inbound Load Balance in Failover mode.
[Vigor3900] What is Bind IP to MAC and how to use it?
Bind IP to MAC feature is used to allocate a fixed IP address for LAN clients based on the client MAC address. This application note shows how to use this feature in the Vigor3900, Vigor2960 and Vigor300B routers.
[Vigor3900] What is Fast Route and When to Use it?
Fast Route is a new feature introduced in firmware version 1.3.1 for the Vigor3900, Vigor2960 and Vigor300B routers. It allows routing between specified networks, such as LAN to VPN, LAN to LAN, VPN to VPN, to skip the checking by CPU and go to the fast route path directly. This feature improves performance by reducing CPU load.
How to set a schedule in Vigor Router and how it works?
This application note shows how to use the schedule feature in Vigor routers to turn on and off the firewall or Wi-Fi signal, or automatically reboot the router according to a time schedule.
How to allow the remote VPN network to access specific local server only?
This application note shows how to restrict remote VPN users to access specific local servers only and prevent them from reaching the rest of the network.
VigorAP 910C V1.2.3
- Added Support for VigorACS 2.
- Add more features (e.g. compression) and parameters (e.g. channel width) for AP management.
- Add “Inform Test Button”, “Last Inform Response Time” and “URL Wizard”.
- Fixed: Potential memory leakage issue.
- Fixed: Several WUI issues (e.g. AP Discovery, data flow monitor) for wireless LAN.
- Fixed: 5GHz channel above 48 was shown as channel 36 if you enabled a 2nd SSID for wireless LAN (country code: DE).
- Fixed: When 2.4G and 5G SSIDs had the same name, 2.4G clients and 5G clients
- could not reach each other.
Click here to download
VigorBX 2000 V220.127.116.11
Refer to the list in the release notes available in the download link.
Click here to download